Legendary Ride Fancy Fold Card

I finally pulled out my Legendary Ride Stamp Set & coordinating dies (also named Legendary Ride) to create a couple of cards to share with you today. 

This card is a Double Z-Fold! I started with a Basic Black card stock base, which was cut at 4-1/4 x 11″ and scored at 2-3/4″ and 5-1/2″.  I folded and burnished the edges with a Bone Folder in accordion fashion.

I adhered pieces of Stampin’ Up! Ready to Ride DSP (now retired) to Pumpkin Pie card stock mats.  I adhered each piece to the card base on the smaller panels.  

I then stamped the sentiment from the Stampin’ Up Legendary Ride stamp set with Memento Black ink on a piece of Very Vanilla card stock.  I adhered the piece of Ready to Ride DSP to the side, then adhered the layers to a Pumpkin Pie mat before adhering it to the card base.

I cut a strip of Basic Black measuring 1-1/4 x 11″ and scored it at 2-3/4″ and 5 -/2″.  I adhered pieces of SU Ready to Ride DSP to each section before adhering it to the card base.  

For the motorcycle, I die cut a scraps of Pumpkin Pie, Basic Black and Silver Foil using the Stampin’ Up Legendary Ride Dies.  I adhered the layers to create the motorcycle.  I adhered the motorcycle to the card front with Tear & Tape.  

I stamped the sentiment from the Legandary Ride Stamp Set on a scrap piece of Very Vanilla card stock, and die cut it out with the Stampin’ Up Something Fancy Dies.  I attached the die cut to the card front with Stampin’ Dimensionals.

I did a couple of quick versions because this was such a fun card to make! 

Dimensions:
    Basic Black: 4 1/4″ x 11″ and 1 1/4″ x 11″ both scored at 2 3/4″ and 5 1/2″
    Pumpkin Pie: 5 3/8″ x 4 1/8″ and 2 5/8″ x 4 1/8″ (2)
    Very Vanilla: 5 1/4″ x 4″ and 2 1/2″ x 2″
    DSP: 2 1/2″ x 4″ (3) , 1 1/8″ x 2 5/8″ (2) and 1 1/8″ x 5 3/8″
 
Supplies:

Thanks so much for hopping by and I hope you have enjoyed todays card!

 

Leave a Reply